This can happen with extremely strong valve springs or when doing the
adjustment, static I assume? ,maybe you were not on the heel of the cam.
Make the adjustments engine running, see what happens.
<schult.cindy@[EMAIL PROTECTED]
> wrote in message
news:cda661f0-76b3-4c9a-81f5-372dcfbb215e@[EMAIL PROTECTED]
> Anybody out there ever seen this in a 454?
> After adjusting rockers to 0 lash + 1/2 turn, I turn the motor over,
> not starting, and low and behold I can turn the push rod again, and if
> I start it, the rockers still clatter. I am running Crane roller
> rockers, new pushrods, new hydrolic lifters, and a new Crane cam. Oil
> pressure is roughly 42 lbs at idle and 190 degrees.
----== Posted via Pronews.Com - Unlimited-Unrestricted-Secure Usenet
News==----
http://www.pronews.com
The #1 Newsgroup Service in the World! >100,000
Newsgroups
---= - Total Privacy via Encryption =---
|
